Decorating Products for Trade Shows & Special Events
Telescopic Drape Supports
Twist Lock Telescopic Drape Supports (Crossbars) consist of two sections of anodized aluminum tubing that telescope one piece inside the other. This allows for adjusting distance between the upright posts.
Hooks on either end attach to slots in the uprights. Locking buttons deploy at set distances for easy setup. Drape Support rods come in a variety of sizes, the most common being 6'-10'.
Also available: non-locking crossbars and a black anodized finish.
2'-3' w/lock @ 3'
3'-5' w/lock @ 5'
4'-7' w/lock @ 7'
5'-8' w/lock @ 8'
6'-10' w/lock @ 8' & 10'
7'-12' w/lock @ 7' & 12'
8'-14' w/lock @ 10'-12'-14'
9'-16' w/lock @ 9'-12'-14'-16'
8'-10' w/lock @ 10', 3pc Breakapart
Curved Drape Support #1
3 piece curved drape support
10ft long with a depth of 24"
Requires 3 uprights and bases
4 sets will make a circle with a circumference of 14.5ft
Curved Drape Support #2
Upward arch curved drape support
10ft or 12ft long
Curved Drape Support #3
1 piece curved drape support
Requires 2 uprights and bases
Double Backwall Hanger
Mounts on top of standard uprights and 2 or 3 pc adjustable upriights. This allows attachment of 2 parallel bars in any (or all) 4 directions.
In Tube Crossbar Hanger(3") and Valence Hanger (8")
Create a valence mounted on backwall uprights. Add a drape support and hang a drape, lights or light weight signs
Clip Rod Supports
Rod clips over any standard or adjustable upright, providing additional support for a short side wall, or banner without requiring additional hardware. Available in the following sizes: 10"-18", 20"-34", 34"-44"
Available in 3ft to 10ft increments
Consists of 2 half circles and only requires 2 uprights and bases
Add telescopic drape supports to various locations across a booth. Additional uprights not required. Brackets easily slip over draped supports. Two required.